I just recently installed knoppmyth on a computer. These are the steps I took to install the program.
It took around 20 minutes to install knoppmyth on the computer. The installation process was pretty straightforward, as there weren't any areas I had trouble handling.
Although, after I rebooted the computer, it said:
ID "c7" was respawning too fast: disabled for 5 minutes
I discovered that all you need to do to bypass this message is press enter. Then it brings you to the root prompt. This error is preceded by the screen flashing a few times as the xserver is trying to start.
The KnoppMyth Pamphlet says the x11 should have started after the auto install, but for some reason it didn't. Not sure why. After that we tried a new graphics card (ATI XL/8M PCI), however upon rebooting we ran into the same problem. The following message was displayed when we tried to manually "startx":
fatal server error: no screens found
We are attempting to get KnoppMyth to display a GUI (graphical user interface), which tells us that the program is running properly. Now we are trying to update the installation to solve the problem.
One thing we noticed was that the debian.geole.info source in /etc/apt/sources.list wasn't responding, so we commented it out. After the upgrade, we ran dpkg-reconfigure xserver-xorg and then startx, and xfce4 appeared! :-)
Now comes the mythtv-setup process. We started this with the command:
The following is an overview of the hardware we used to build our mythtv settopbox: